Your Whirlpool dryer is flashing a code — here's what it's telling you, whether you can fix it yourself, and when to call an OKC dryer specialist. Codes can vary by model year, so confirm against your manual.
Exhaust thermistor (temperature sensor) fault — open circuit.
Likely cause: A failed exhaust thermistor or its wiring harness.
What to do: The thermistor needs replacement; a technician should confirm the wiring too.
Main control board failure.
Likely cause: A fault on the main electronic control board.
What to do: Typically requires control board service or replacement.
Power failure — the cycle was interrupted.
Likely cause: Power loss during the cycle.
What to do: Press start to resume. Recurring without outages means the board needs a look.
Restricted airflow.
Likely cause: A clogged vent or lint screen restricting exhaust.
What to do: Clean the lint screen and vent. If it persists after a full vent cleaning, call us.
Thermistor short or open.
Likely cause: Temperature sensor failure or wiring issue.
What to do: Have the sensor and wiring tested.
Slow drying, no heat, a burning smell, or just due for a cleaning? Book online or call an OKC-metro dryer specialist today.
